Installation Procedure

Double Side Application – Wall Panel above Surecove

1. Saw- cut 6 mm width x 15 mm depth, adjacent to the wall, off set 305 mm apart, outide line to outside line of saw-cut, for 100 mm thick wall panel
2. Clean / remove dust and debris from wall and saw-cut, ensure surfaces are dry
3. Drill holes and place N12 starter bars @ 400 mm centres, between saw-cuts
4. Drill 8 mm holes in floor for brackets, offset 110 mm from outside line of saw-cut at 800 mm centres
5. Place Steel retaining brackets with 60 mm masonary sleeve anchors
6. Cut Surecove product length to suit application
7. Apply 2 – Part Epoxy (Sikadur 31) x 60mm, into Saw-cut at 600mm centres and at corner sections with Spatula
8. Place Surecove into saw-cut, joining lengths with Surecove offcuts to rear face with Loctite 406 adhesive
9. Using a string line, align Surecove product at top, and tighten masonary sleeve anchors to secure brackets
10. Apply Sikaflex 11fc along saw-cut and bottom of Surecove product to seal, after epoxy has hardened / cured
11. Place and tie N12 rod longitudinally to N12 starter bars and backfill Surecove product with concrete mix